Advertisement
Quick Links
****
IMPORTANT NOTICE
****
.f""""".
The
diagram
below
shows
the
proper
method
of
sett~ng
the
DIP-switches used on GIMIX boards
and
systems.
A
special
tool
for
setting
the
switches
has
been
included.
Use of this tool will make
setting of the switches
easier
and
prevent
possible
damage
to
the
switches
caused by the use of pens, pencils, screwdrivers, etc.
To set
the switches use the tip of the tool to depress the switch rocker at the
end
nearest
the desired function, as marked on the body of the switch.
Be sure that the rocker is fUlly depressed and has snapped into place in
the
desired
position.
In
the following example sections 1 and 3 are
shown OFF (OPEN) and section 2 is ON (CLOSED).
Depress this end of the switch rocker
to set a switch section ON (CLOSED).
o
N
3
2
o
F
F
The RED BAR will appear here
when a switch is set OFF (OPEN).
Depress this end of the switch rocker
to set a switch section OFF (OPEN).
-
"
The RED BAR will appear here
when a switch is set ON (CLOSED).
C2/3/82 GIMIX Inc.
Advertisement
