Table of Contents
Advertisement
4.
Install the blind nut in the wheel pant using the
4-40 bolt to pull it into the hole.
Landing Gear
Wheel
5.
Mount the wheel pant on the landing gear
along with the wheel collars and wheels.
Center the wheel on the axle.
Use the 4-40 x 1/2" bolt to hold the wheel pant
to the gear.
Be sure to use thread lock on the bolts.
Wheel Pant
Wheel Collars
9
HINGING RUDDER
1.
Locate the rudder, four hinges and the tail
wheel bracket.
Use the 3/6" drill and drill each hinge hole 1/8"
deep so the shoulder of the hinge will fit
the hole up to the hinge pin.
Do the same on the hinge holes on the fin.
Fit the tail wheel bracket in place.
2.
Trial fit the rudder in place on the fin. Make
sure the hinge line is tight and the counter bal-
ance does not rub on the top of the fin.
Insert a piece of wire into the outlet hole for
the rudder cable (holes on bottom are rudder,
holes on top are elevator) and make a mark
on the rudder in line with the outlet hole.
into
Advertisement
Table of Contents
