Bosch SPV68U53UC Operating Instructions Manual page 17

Start the dishwasher
1
Press the [On/Off] button.
2
Select a cycle and desired options and press [Start].
Cancel a Cycle
1
Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
2
Wait about 1 minute while the dishwasher drains.
3
Press the [On/Off] button.
Interrupt a Cycle
1
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the [On/Off] button.
Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1
Press the [On/Off] button.
2
Hold down the "A" button (see page 14) and press [Start] until the display indicates "H:00".
3
Release both buttons.
4
Press the "A" button until the display shows "r:04".
5
Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
6
Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to "h:01".
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until "h:00" is indicated on the digital display.
2
Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
15