Meridian 551 User Manual page 32

The following table gives details of the audio outputs:
Use this output
Right/Left Output
Pre-amp Out
Tape Out
To connect to a tape recorder
Connect the analogue output from the tape recorder to the
Tape 1 input on the integrated amplifier (or another input if
you prefer).
Connect the Tape Out from the integrated amplifier to the
analogue input on the tape recorder.
28
To connect to this
Loudspeakers of 4 to 15 , using
either banana plug or bare wire
connections.
An additional power amplifier or active
loudspeakers.
Tape recorder output.
To connect to other Meridian 500
Series equipment
Connect one of the COMMS sockets on the back panel of the
integrated amplifier to one of the COMMS socket on another
500 Series unit, using the 500 comms lead.
The sequence in which you connect the units is not important.
COMMS
Then configure the units with the following automatic setup
procedure:
Switch all the units to standby.
Press Clear on the remote.
Each unit will display:
One unit will then be designated
as the controller, and display:
COMMS
Auto
Con