Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JSI 4170
Summary of Contents for JSI 4170
- Page 1 4170 4180 CHIMNEY HOOD (ISLAND) USER MANUAL 4170 MODEL 4180...
-
Page 2: Introduction Of The Product
INTRODUCTION OF THE PRODUCT Cooker-hood does not work Illumination Lamp does not work Cooker-hoods air suction is weak 4170 Cooker-hood does not direct air out 4180 (at places without chimney) 1 –Chimney 2 – Body If the product does not work: Before you contact the technical service: 3 –... -
Page 3: Technical Specifications
WARNINGS AND SAFETY PRECAUTIONS TECHNICAL SPECIFICATIONS *This product is designed for usage at *Flaming foods should not be cooked Model 4170 4180 home. under the product. Feeding Voltage 220-240 V 50Hz Lamp Power (W) 2 x 20 W 2 x 35 W... - Page 4 *When chimney hood and the Usage of remote control *Be sure that your child does not play appliances working with energy other with the product. Do not allow kids to You can use your chimney hood with remote control. Please follow below than electricity are operated at the use your product.
- Page 5 Usage of 5 Speed Digital Control Standard Accessories Usage Remove protective folio on the inox product after installation. Plastic chimney Speed Selection The product has 5 speeds of ventilation level. One of 1,2,3,4,5 Plastic chimney is applied to chimney hood speeds is selected in accordance with steam of cooking or fry.
-
Page 6: Maintenance
MAINTENANCE MONTAGE OF ISLAND CHIMNEY HOOD *Disconnect electricity connection before 1)Distance between motor block and gas hob maintenance and cleaning process. should be 84cm, distance between motor block *Aluminum cassette filter holds the dust and the and electrocal hob should be 94cm. Figure 4 oil in the air. - Page 7 Active Carbon Filter 10)Fix one side of the aluminum flexible duct to Aluminum To provide air recirculation where product's product's plastic chimney and the other end to flue outlet chimney air outlet cannot be connected to kitchen chimney. (Make sure that this exterior, it is necessary to use active carbon connection is so tight that it will not be filter with your product.
- Page 8 Replacing the Lamps 12)Place body of the poduct on motor block. Cut off the connection of the cooker hood with Figure 9 electricity. Take off the aluminum cassette filter. Take off the failed lamp and replace it 13)Pass hanging holes to the plastic headed with a new one that is of the same rating.