Sony KV-32S42 Service Manual page 21

V. SIZE ADJUSTMENT (VSIZ)
1. Input a cross-hatch signal.
2. Set to Service Adjustment mode.
3. Select VSIZ with and
4. Adjust with and for the best vertical size.
V SIZE
V. POSITION ADJUSTMENT (VPOS)
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VPOS with and
4. Adjust with and for the best vertical center.
5. Write into the memory by pressing
**.
V POSITION
H. POSITION ADJUSTMENT (HPOS)
1. Input a cross-hatch signal.
2. Set the Service Adjustment Mode.
3. Select HPOS with and
4. Adjust with and for the best horizontal center.
5. Write into the memory by pressing
**.
H. POSITION
V LINEARITY (VLIN), V CORRECTION
(VSCO), PIN AMP (PAMP) AND PIN PHASE
(PPHA) ADJUSTMENTS
1. Input a cross-hatch signal.
2. Set to Service Adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
4. Adjust with and for the best picture.
5. Write the memory by Pressing
V LINEARITY(VLIN)
VS CORRECTION (VSCO)
**WARNING: Do NOT turn off the power or AC immediately after pressing
.
.
then
.
then
and .
then ** .
KV-32S42/32S66/32V42/35S42/35S66/35V42
PIN AMP (PAMP)
PIN PHASE (PPHA)
V ANGLE (VANG), V BOW (VBOW), UPPER
PIN (UPIN) AND LOW PIN (LPIN)
ADJUSTMENTS
1. Input a cross hatch signal.
2. Set to Service adjustment Mode.
3. Select VVANG, VBOW, UPIN, and LPIN with
4. Adjust with and
5. Write the memory by Pressing
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
P BOARD ADJUSTMENTS
PIP V. POSITION (PIPV), PIP H. POSITION
(PIPH)
1. Input a color bar signal.
2. Set to service adjustment mode.
3. Select PHOP with
4. Adjust with and
corner P in P display position.
5. Adjust P in P put at lower right position.
6. Write the memory by Pressing
then
— —
21
and
for the best picture.
then
and .
for the best balanced position at four
then
. Wait at least 10 seconds.
.
** .
**.