D-Link DIR-615 User Manual page 33

DIR-615 Wireless N 300 Router
User Manual
Click the Reboot line if you have already saved the router's settings.
Click the Save&Reboot line to save new settings and immediately reboot the router.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the router) to your PC. Also you can save the router's configuration to your PC via the Backup
button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware RESET button. The hole of the
button is located on the back panel of the router. Use a small paperclip to activate the button; insert
it into the hole (with the router turned on), push, and hold for 15 seconds. Then remove the
paperclip. Wait for about 30 seconds. Now you can access the web-based interface of the router
using the default IP address, username and password.
When you have configured all needed settings, click the Logout line.
Figure 23. The top-page menu.
Page 33 of 172
Installation and Connection