COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
SECTION 2 TEST MODE DISPLAY / KEY TEST MODE Press the ENTER/NEXT and FUNCTION buttons simultaneously. Then press the MENU 1 button with the following 4 seconds to set the Test Mode. 1. The message “W1 J (destination) ” appears on the screen and a 32 cycle square wave of the subcrystal oscillator is output from Pin 24 (AUB.
SECTION 3 ELECTRICAL ADJUSTMENTS Precautions in Repairing Adjustment Location : The adjustment should be performed in the publication. Note. 1 : (AM nFM) Note. 2 : As a front-end (FE1) is difficult to repair if faulty, replace it [ TCB BOARD ] – Component side – with new one.
SECTION 4 EXPLANATION OF IC TERMINALS IC501 1 ASD0204GF-011-3BA (SYSTEM CONTOROL) Pin No. Pin name Description – Power supply. CLK OUT Direct output for communications with HCD-W55. RDY IN Direct input / output for communications with HCD-W55. POWER ON / OFF L : Relay ON MUTE Mute output to transistor.
Page 7
Pin No. Pin name Description RDS DATA Not uset. System control data signal input / output. System control data signal input / output. System control data signal input / output. System control data signal input / output. – Power supply +5V. SIRCS IN SIRCS signal input.
SECTION 6 EXPLODED VIEWS NOTE : The components identified by mark The mechanical parts with no reference num- -XX, -X mean standardized parts, so they may ! or dotted line with mark ! are criti- ber in the exploded views are not supplied. have some difference from the original one.
Page 17
SECTION 7 MAIN ELECTRICAL PARTS LIST NOTE : SEMICONDUCTORS Due to standardization, replacements in the In each case, u : µ , for example : The components identified by mark parts list may be different from the parts speci- uA..: µ A.., uPA..: µ PA..! or dotted line with mark ! are criti- fied in the diagrams or the components used on uPB..