TSM -22 Operating Manual

TSM-22 Operating Manual
Notice to Owners and Operators:
The TSM-22 Meat Grinder is designed to grind meat product safely and efficiently. Unless the
operator is properly trained and supervised, however, there is the possibility of a serious injury. It
is the responsibility of the owner to assure that this machine is used properly and safely, strictly
following the instructions contained in this manual and any requirements of local law.

Main Precautions:

The TSM-22 can be a potentially dangerous machine when used incorrectly. Therefore, read all
the following instructions carefully to avoid damages. FOR COMMERCIAL USE ONLY by
qualified operators. BEFORE cleaning, disconnect machine from power source. NEVER use tools
not belonging to the machine to help operation. NEVER feed by hand. Always use the stomper.
NEVER put your fingers or any other object but the stomper inside the feed throat. NEVER
connect power source with wet hands or wet clothes. NEVER spray water or other liquid
substances directly at motor, power switch or any other electrical components. KEEP your
working are clean and dry to prevent it from becoming slippery. ALWAYS install epuipment in
working area with adequate light and space away from children and visitors. NEVER operate
without all warning labels attached and owner/operator manual available to operator. NEVER
leave unattended while operating. STOP the machine immediately if you hear abnormal noises,
of fear that injuries may occur. ALWAYS ground the machine properly. CONTACT The Sausage
Maker if you have any problems with the installation and operation of this machine.

Main Components:

The machine consists of an electrical motor that, through a gear box, operates a worm. The worm
feeds the meat to the knife and grinder plate. Several types of grinder plates are available. The
plates have holes with different diameters. The type of plate is chosen depending on the desired
ground meat characteristics.
The feed throat and worm receive a special treatment to isolate and facilitate the cleaning. The
knife and disc are made of hard material to provide a long life cutting quality.

Technical Data:

• Voltage: 110V
• Frequency: 60Hz
• Consumption: 1,2kW/h
• Height: 380mm
• Width: 380mm
• Depth: 710mm
• Net Weight: 45kg
• Gross Weight: 49kg
• Average Production: 300kg/h

Installation:

The meat grinder must be installed on a level, non-skid surface with a maximum recommended
height of 850mm by qualified or experienced people. In front of the grinding device must be left a
suitable space to receive a tray to collect the processed meat. Check the voltage of the machine.
The unit voltage must be the same as the power source. Grounding wire must always be
connected.

Pre-Operation:

Check if the machine is firm, no movement shall be allowed on the supporting surface. It is
recommended that the machine be carefully cleaned before first operation. (Clean as explained in
the "Cleaning" section) After cleaning, reassemble the components following the order shown in