Advertisement
Quick Links
Advertisement
Summary of Contents for Inter Page VP100
- Page 1 VP100 TONE-VOICE PAGER Programming Instructions 1-800-992-1000 or 561-844-7900 Ext 4...
- Page 2 These instructions are written specifically for VP100 Programmer Version 3.7.8. There may be some overlap for earlier versions of the programmer system, but these items are not guaranteed to be applicable for these earlier versions. In addition, the VP100 must have Version 1.88 firmware or later.
-
Page 3: Software Installation
If there appears to be nothing wrong, then you should contact technical support at Inter Page – (800)992-1000 or (561)844-7900 Ext 4. Please make a note of the pager VERSION that will be displayed on the upper left part of... - Page 4 If you use this feature, then you must go to the ADVANCED SETTING tab and set the C TONE ALERT TIME to 4 Seconds. (NOTE: The PASSWORD to get into the ADVANCED SETTING mode is VP100. Do not change any other parameter other than the ALERT TIME in the ADVANCED SETTING mode.) A short dissertation on how to get maximum benefit of group paging is found at the end of this manual.
-
Page 5: Reset Control
RESET CONTROL The RESET CONTROL determines how the pager operates once that pager has received a call. This MODE control is very important for all users of a system. Because it is so important, this is the only field that has a HELP screen for this function. There are 6 modes, and if not set properly, you will not be satisfied with this pager. - Page 6 4. TIME OUT RESET allows the speaker to only be open for N second after TONE 2 stops. The number of seconds (N) is also programmed on the same line as the mode here. Again, only commercial paging carriers will be interested in this mode, and then, mode 1 is better for them.
- Page 7 FILE, then SAVE-AS, and then entering the pager ID or person’s name on the file name that will be stored in the VP100 directory. You might want to do this for each pager in the system that has a different cap code.
- Page 8 PROGRAMMING THE PAGER Once you have all of the parameters set as you desire them to be, then you need to program the pager by LEFT CLICKING on PAGER and then WRITE, or just press the F4 key. If everything is OK, then WRITE SUCCESS will appear on the screen. Please reset the battery after each programming to ensure pager is updated with new information.