Code Entry; Direct Code Entry; Code Search - NexxTech 1519006 Manual

Direct Code Entry

1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP
button.
2. Press and release the desired mode button (TV,
VCR, etc.). The red indicator blinks, then stays
lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry,
the red indicator turns off. For an invalid code,
the red indicator flashes.
4. With your device on, press POWER. If the
device turns off, no further programming is
required. Note: If some buttons do not operate
your equipment, try one of the other codes for
your brand.
Write your codes down here for easy reference
later.
Device Device stored Code
TV
VCR
DVD
SAT/CBL
TV
6

Code Search

If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device (TV, VCR, etc.) to
be controlled.
2. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP
button.
3. Press and quickly release the desired mode
button (TV, VCR, etc.). The red indicator blinks
once, then stays on.
4. Press the POWER button repeatedly (up to 300
times) until the device to be controlled turns off.
The red indicator blinks off with each button
press.
5. Press and release ENTER to install the code.
Most users will store VCR codes under the VCR
button, Cable codes under CABLE, etc. If (for
example) you want to store a VCR code under
CABLE, first follow the procedure for Direct Code
Entry (page 6) and press CABLE in step 2 of Direct
Code Entry, then enter ANY VCR code in step 3 of
Direct Code Entry. Then follow the steps above for
Code Search.
7