Porsche 2007 Cayenne Owner's Manual page 343

3. Unscrew the wheel bolts A with which the
spacer is fastened.
4. Remove the spacer.
5. Remove assembly aid from the tool kit and
screw in instead of the wheel bolt.
6. Fit wheel.
7. Use the wheel bolts A with which the spacer
was fastened to mount the wheel.
Insert wheel bolts and tighten by hand.
Remove assembly aid and screw in remaining
wheel bolt.
Initially tighten bolts in diagonally opposite
sequence so that the wheel is centred.
8.Inflate the tire if necessary.
Please observe the chapter "TIRE PRESSU-
RES, COLD" on Page 406.
On vehicles with Tire Pressure Monitoring:
Please observe the chapter "SETTING THE
TIRE TYPE AND SIZE" on Page 157.
9.Lower the car and remove the jack.
10.Tighten wheel bolts in diagonally opposite
sequence.
Maintenance Note
f Immediately after changing a wheel, use
a torque wrench to check the prescribed
tightening torque of the wheel bolts
(160 Nm/118 ftlb.).
f Spacer, steel nuts, and plastic covers should
be stored together.
Fitting the 17 mm spacer
1. Remove wheel.
2. Fit the spacer with the wheel bolts A used to
fasten the wheel.
Tightening torque: 160 Nm (118 ftlb.)
3. Fit wheel.
To do this use the original wheel nuts for
fastening the wheels.
Tightening torque: 160 Nm (118 ftlb.)
Place plastic covers onto the steel nuts.
Note
There is no anti-theft protection for the wheel nuts.
Minor Repairs
343