table of contents caUtIon Warnings and Cautions ......................... 2 • TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. THERE ARE NO SERVICEABLE PARTS INSIDE. FCC information ..........................6 • TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS Location of Parts and Controls ....................
Page 3
DanGer The unit should be situated away from direct sunlight or heat sources such as radiators, electric heaters, heat registers, stoves, or other units (including To reduce the risk of electric shock, burns, fire or injury: amplifiers) that produce heat. Avoid placing on top of stereo equipment that radiates heat.
WarnInG! fcc InforMatIon This device complies with Part 15 of the FCC Rules. Operation is subject to the This ProducT conTains a rechargeable baTTery following two conditions: • Do not store this product in high temperatures, damp areas or in This device may not cause harmful interference.
locatIon of Parts anD controls locatIon of Parts anD controls 3.5mm Audio Out USB Out (5V) 500mA max. Touch-sensitive Mode HDMI Touch-sensitive Volume Up 12V Jack Touch-sensitive Volume Down Reset Button Backlit Battery Indicator Light On/Off Slide Switch boTToM Tripod Dock Rubber Feet (4)
locatIon of Parts anD controls coMPatIbIlItY Projector Lamp YoUr DevIce Do YoU neeD an aDaPter? Focus Wheel Apple® iPad®, iPhone® Yes — Apple Digital AV AC Adapter (not shown) and iPod touch® devices (sold separately) HDMI Cable (not shown) Other smartphones, tablets Yes —...
cHarGInG tHe Projector PoWerInG UP anD vIeWInG MeDIa The Projector is charged using the included AC Adapter. Power on the Projector by sliding the Power Switch to on. The LED Indicator Light will illuminate Red to indicate the Projector is Touch the Circle Mode area on the top of the Projector, the screenwill then currently charging and then revert to Green when the Projector is fully show you a choice of two modes, “Standard”...
aDjUstInG volUMe cHarGInG YoUr DevIce WItH tHe Projector Touch Mode area first to highlight. Adjust the volume of your video by lightly touching on the + or – symbols on the top of the Projector. The Projector will also work as a back-up battery for your smartphone device. aDjUstInG focUs Connect your device to the fully-charged Projector with a USB cable (not included).
troUblesHootInG sPecIfIcatIons The Projector will not show the video on the wall. Recharge your device’s battery. Also, check to see if the HDMI cable is fully natIve resolUtIon 854 - 480 (WVGA) inserted into the Projector and your device. leD laMP 85 Lumens The video showing on my wall is blurry.
This for a new or remanufactured Product. If Telstar, in its sole discretion, determines it is not limited warranty gives you specific legal rights, and you may also have other rights that reasonable to replace the defective Product, the retailer may refund to Consumer the vary from state to state.
Need help?
Do you have a question about the MP50 and is the answer not in the manual?
Questions and answers