Table of Contents
Advertisement
Quick Links
Flame Heater – PH08 SERIES
ASSEMBLY AND OPERATION INSTRUCTIONS
IMPORTANT DO NOT RETURN
AZ Patio Heaters insists on highest standard of quality in manufacturing your heaters.
Each of them has been carefully inspected before shipment. In case of any issues,
please DO NOT RETURN TO STORE.
Call us at 1-888-775-1330 between 8:00 AM to 4:00 PM PST Monday to Friday.
WARNING
Read these instructions before using this appliance.
The appliance must be installed in accordance with
the instructions and local regulations. The use of this
appliance in enclosed areas can be dangerous and
is PROHIBITED.
Do the leak test after each changing of LPG
•
cylinder.
Never check for leaks with a match or open flame.
•
Do not store or use gasoline or other flammable
•
vapors and liquids in the vicinity of this appliance.
IF YOU SMELL GAS
•
Close the valve of the gas cylinder or regulator.
•
Extinguish all naked flames; do not operate any
electrical appliances.
•
Check for leaks as detailed in these instructions.
•
If odor persists, cotact your dealer or gas supplier
immediately.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for AZ Patio Heaters PH08 Series
- Page 1 If odor persists, cotact your dealer or gas supplier immediately. IMPORTANT DO NOT RETURN AZ Patio Heaters insists on highest standard of quality in manufacturing your heaters. Each of them has been carefully inspected before shipment. In case of any issues, please DO NOT RETURN TO STORE.
-
Page 2: Carbon Monoxide Hazard
PRECAUTIONS DANGER CARBON MONOXIDE HAZARD • Installation and services should only be a qualified person. • Do not use the heater in an explosive atmosphere. T h i s a p p l i a n c e c a n p r o d u c e c a r b o n •... -
Page 3: Leakage Test
APPLIANCE STAND AND LOACTION LEAKAGE TEST Gas connections on the appliance are leak tested at the factory prior to shipment. Possible mishandling of the appliance during the shipment might contribute to product integrity as a whole. A complete gas - The appliance is for outdoor use only. Do not use leakage test must be performed again at the installation site. -
Page 4: Parts List
PARTS LIST-1 PARTS LIST-2 PART NUMBER PART NAME PICTURE QUANTITY DESCRIPTION PART NUMBER PART NAME PICTURE QUANTITY DESCRIPTION SIDE PANEL A REFLECTOR MESH GUARD SIDE PANEL B WITH HANDLE LOWER WITH FOOT HANDLE ALUMINUM TUBES UPPER KNOB WITH CHAIN ATTACH TO THE ALUMINIUM TUBES FRONT PANEL WHEEL... -
Page 5: Heater Assembly
HEATER ASSEMBLY STEP 4: Take off 9pcs M3/16 screws(CC) from lower aluminum tubes(C),and attach the middle plate with control box(K) into the lower alumunum tubes(C) with 3pcs M3/16 screws only. STEP 1: Notice:Bottom plate with holes and the control box with knob should be at the same side, Take off the M5x10 screw(BB),attach the bottom plate(R) into the lower aluminum tubes(C). - Page 6 STEP 9: Put the rubber ring(J) into the middle plate hole,then insert the glass tube(I) into the heater by holding the base in one hand,top in the other,and insert the tube underneath the upper plate STEP 7: Take off the M3/16 screws(CC)from upper plate(E),then attached the upper plate with screen into the upper aluminum tubes(D) STEP 8:...
-
Page 7: Operation
OPERATION STEP 11: Assemble the mesh guard(B) into the heater to match the hook in the aluminum tubes,then screw the guard fastening pieces(H) together with matching 3/16 screws on the top of the upper plate to Preparation: You will need to purchase a LPG cylinder designed to be used with the regulator purchased. -
Page 8: Cleaning/Maintenance/Storage
CLEANING/MAINTENANCE/STORAGE Troubleshooting CLEANING AND MAINTENANCE: PROBLEM PROBABLE CAUSE SOLUTION ● To enjoy outstanding performance of your heater for years make sure to perform the following maintenance activities on a regular basis: Pilot will not light Gas valve may be OFF Turn the gas valve ON ●...
Need help?
Do you have a question about the PH08 Series and is the answer not in the manual?
Questions and answers