Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Ningbo Manuals
  4. Washer
  5. DW-1300K
  6. Service manual

Ningbo DW-1300K Service Manual

Twin-tub washing machine
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
Twin-tub Washing Machine

SERVICE MANUAL

MODEL NO.: DW-1300K
NINGBO KINGSUN GROUP CO., LTD
Please read this manual carefully before operating your Washing Machine.
Please record model number and serial number on the Rating Label and quote
this information to your dealer when you require service.
This Washing Machine is designed and manufactured for household use only.

Advertisement

loading
Need help?

Need help?

Do you have a question about the DW-1300K and is the answer not in the manual?

Questions and answers

Summary of Contents for Ningbo DW-1300K

  • Page 1: Service Manual

    Twin-tub Washing Machine SERVICE MANUAL MODEL NO.: DW-1300K NINGBO KINGSUN GROUP CO., LTD Please read this manual carefully before operating your Washing Machine. Please record model number and serial number on the Rating Label and quote this information to your dealer when you require service.
  • Page 2 Contents The Exploded View twin-tub washing machine The Parts List of twin-tub washing machine III. Troubles Shooting IV. Repair main points and notes V. The circuit diagram...
  • Page 6 Causes and settlements Troubles Causes Settlement Washing is forceless,pulsator 1. Belt loosen 1. Tighten or Replace the belt work slowly 2. Too much washer 2. Decrease the washer 3. Low voltage 3. Wash after the refresh of voltage Pulsator, spin tub can’t work 1.No power(power cut or fuse break 1.Check the power and no sound from the motor...
  • Page 7 pipe surface damaged replace the pipe 4.Rubber cap damaged 4.Replace rubber cap 5.The drain valve is not sealed well 5.Adjust the drain valve pole’s right height or clean the foreign matter or replace the drain valve The drain pump failure to 1.Drain valve not opend 1.Open the drain valve drain when washing...
  • Page 8 1. Cut off the power 2. Pull out the knob on the wash program 3. Screw off the screws between the control panel(and panel back cover) and the tub 4. Unclamp the plug-in package 5. Screw off the screws fixed on the wash program,then take out the wash program 6.
  • Page 9 Clean the foreign matters on the spin tub shaft 1. Cut off the power 2. Open the panel frame,screw off the screws off middle frame, and take out th middle frame 3. If can’t take out the foreign matters under the above condition, please open the machine rear cover 4.