Table of Contents
Advertisement
BHAS01UR
Programming your learning remote control
Your remote control is set to work your digital set top box only. However, it is
possible to programme it to also control your TV set, so that you only need to use
one remote control.
When you have programmed your remote control, the following buttons will control your
TV
,
,
Programming your remote control using the four digit code
Find the make of your TV in the code table listed from page 33 of this instruction manual .
Keep the four digit codes for your TV close to hand while programming your remote
control .
If there is no code for your TV, or the supplied codes fail to work, please refer to the
the 'Programming using the search facility' section on the following page.
1
Make sure that you are pointing the remote control at the TV and not at your digital
box .
2
Press both the
button flashes twice . Release the keys .
3
Enter the first four digit code from the list of codes for your make of TV . The top left
button
press the fourth button, to confirm that you have entered a valid code .
4
Press the
process trying another code from the table .
5
If none of the codes work, try using the search facility explained below .
6
When the TV switches off, you will know that you have found the correct code .
Your remote control will remember this code even if you replace the batteries .
7
Once you have programmed your remote control to switch your TV on and off you
can programme it to control your TV volume and mute functions (to turn the sound
off completely) . Before you can do this, make sure that you have not turned down
or muted the volume from your digital box .
a) Press both the
down until the light under the
now work the volume and mute functions of your TV .
8
This Manual: http://www.manuallib.com/file/2591300
and
.
button and the
will flash once every time you press a button and then twice after you
button and the TV should switch off . If it doesn't, repeat the whole
button and the
button (at the same time) until the
button (at the same time) and hold them
button flashes twice . Your remote control will
Advertisement
Table of Contents
