Troubleshooting - Garrison 046-5681-0 Instruction Manual

11
model no. 46-5681/46-5682 046-5681-0 to 046-5681-8 & 046-7244-0 to 046-7246-6
Set Autolock Time Delay
Enter Seconds
6
Enter PC
(10~99)
Remark: 10-99 seconds delay-time available.
Toggle Mute On/Off
7
Enter PC
Remark: Repeat same steps to turn beeper On/Off.
LED illumination is still functioning when it's in mute.
But there will be no any warning alarm.
Enable/Disable All User Code
8
Enter PC
Remark: Auto-locking and Keypad locking functions will be invalid when User Codes
are disabled. The lock can only be operated by key during the time.
Repeat the steps to enable the User Codes again.
Create a disposable User Code
Enter new
9
Enter PC disposable
Remark: Disposable code will be no longer valid once being used.
Restore all preset lock settings
R
Press
Remark: Press "R" button for over 5 seconds, the programming will complete
after you hear 3 long beeps.
After restoring default settings, you need to run the door handing
identifying process before other setting any other functions.
46_5681_46_5682
PROCESS
MAGENTA
WO 01a
Date 11/08/13
Brenda
Artist
Simple Troubleshooting
Programming Code (PC)
USER Code (UC)
Problem
After the installation of the
lockset and batteries, the
door cannot be locked
and three short beeps are
emitted when you press
the Programming button.
After the installation of the
lockset and batteries, no
responses when you press
any button (no sounds are
emitted, and the back
light does not work).
Fail in the first execution
of the door-handing
indentifying process
(the red light flashes three
times, and three short
beeps are emitted).
Although succeeded in
the first execution of the
UC
door-handing indentifying
process, the latch does
not work. (Feeling that the
motor runs powerlessly,
the latch bolt is stuck,
and the turn-piece inside
cannot be rotated).
638604 CTC Generic 815446
PANTONE PROCESS PANTONE PANTONE
287C BLACK 000 000
02a 02a 02b 03a 04a 05a 06a
11/26/13 mm/dd/yy mm/dd/yy 11/29/13 mm/dd/yy mm/dd/yy mm/dd/yy
Brenda xxxxxx Brenda xxxxxx xxxxxx xxxxxx xxxxxx
12
Reason Solution
The door-handing Please execute the door-
indentifying process is not handing indentifying
yet complete. process as soon as the
installation of the lockset is
completed.
It could be a problem Check to see if the battery
caused by the batteries or polarities have been
the improper connection of reversed or if the battery
the cable. is dead. If so, please
re-install or change the
battery. If not, please
check if the cable is
appropriately connected.
Wrong door-handing Press the R button to
or change of the restore the system to
door-handing in factory default settings
the memory. and re-execute door-
handing indentifying
process.
Low battery. Please replace with new
batteries.
LITHO FLEXO
PANTONE
000
07a
mm/dd/yy
xxxxxx