Do you have a question about the 371AAV and is the answer not in the manual?
Questions and answers
Dennis Salisbury
February 2, 2025
How to light the pilot light?
1 comments:
Mr. Anderson
February 10, 2025
The Day and Night 371AAV is a modern gas furnace with an electronic ignition system, meaning it does not have a traditional pilot light that needs to be manually lit. Instead, it uses an automatic igniter to start the burner when heating is required.
If the furnace is not igniting, follow these steps:
1. Turn Off the Power - Locate the furnace’s power switch (usually near the unit) and turn it off. - Alternatively, turn off the circuit breaker that supplies power to the furnace.
2. Check the Gas Supply - Ensure the gas valve is fully open. If it was closed, open it slowly.
3. Reset the Furnace - Locate the reset switch or power switch on the furnace. - Wait at least 5 minutes to allow any residual gas to dissipate. - Turn the furnace back on.
4. Check the Thermostat - Set the thermostat to heat mode and increase the temperature to trigger the furnace.
5. Listen for Ignition - The furnace should initiate its ignition sequence, where the electronic igniter lights the burners.
6. Inspect for Issues - If the furnace still doesn’t ignite, check for error codes on the control board (usually a blinking LED light). - Ensure the flame sensor is clean, as a dirty sensor can prevent ignition.
7. Call a Professional - If the furnace does not ignite after resetting, contact a qualified HVAC technician for further troubleshooting.
Since the Day and Night 371AAV uses an electronic ignition system, there is no manual pilot light to relight.
Need help?
Do you have a question about the 371AAV and is the answer not in the manual?
Questions and answers
How to light the pilot light?
The Day and Night 371AAV is a modern gas furnace with an electronic ignition system, meaning it does not have a traditional pilot light that needs to be manually lit. Instead, it uses an automatic igniter to start the burner when heating is required.
If the furnace is not igniting, follow these steps:
1. Turn Off the Power
- Locate the furnace’s power switch (usually near the unit) and turn it off.
- Alternatively, turn off the circuit breaker that supplies power to the furnace.
2. Check the Gas Supply
- Ensure the gas valve is fully open. If it was closed, open it slowly.
3. Reset the Furnace
- Locate the reset switch or power switch on the furnace.
- Wait at least 5 minutes to allow any residual gas to dissipate.
- Turn the furnace back on.
4. Check the Thermostat
- Set the thermostat to heat mode and increase the temperature to trigger the furnace.
5. Listen for Ignition
- The furnace should initiate its ignition sequence, where the electronic igniter lights the burners.
6. Inspect for Issues
- If the furnace still doesn’t ignite, check for error codes on the control board (usually a blinking LED light).
- Ensure the flame sensor is clean, as a dirty sensor can prevent ignition.
7. Call a Professional
- If the furnace does not ignite after resetting, contact a qualified HVAC technician for further troubleshooting.
Since the Day and Night 371AAV uses an electronic ignition system, there is no manual pilot light to relight.
This answer is automatically generated