Disclaimer And Limitation Of Liability - VTech InnoTV User Manual

(i) encode video in compliance with the AVC standard ("AVC video")
and/or
(ii) decode AVC video that was encoded by a consumer engaged in a
personal activity and/or was obtained from a video provider licensed
to provide AVC video.
No license is granted or shall be implied for any other use. Additional
information may be obtained from MPEG LA, L.L.C. See
http://www.mpegla.com

Disclaimer and Limitation of Liability

VTech Electronics North America, L.L.C. and its suppliers assume no
®
responsibility for any damage or loss resulting from the use of this
handbook. VTech Electronics North America, L.L.C. and its suppliers
®
assume no responsibility for any loss or claims by third parties that
may arise through the use of this software. VTech Electronics North
®
America, L.L.C. and its suppliers assume no responsibility for any
damage or loss caused by deletion of data as a result of malfunction,
dead battery, or repairs. Be sure to make backup copies of important
data on other media to protect against data loss insert line break.
Company: VTech
Electronics North America, L.L.C.
®
Address: 1156 W. Shure Drive, Suite 200, Arlington Heights, IL 60004
USA
Phone : 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
16