NETGEAR ReadyNAS 102 Hardware Manual page 109

Make sure that the HDD or SSD is installed on the correct side of the disk tray.
WARNING:
To prevent damage to your system, make sure that the disk tray is
correctly oriented before inserting it into the drive bay.
5. Insert the disk tray back into the drive bay of the storage system.
• For 2-bay and 4-bay systems, insert the disk tray so that the disk tray release latch is
near the bottom of the system.
• For 6-bay systems, insert the disk tray so that the disk tray release latch is on the left
side of the system.
6. Press down on the disk tray handle until it latches closed.
The disk tray is secured in the drive bay.
If the volume that contained the failed disk uses a protected RAID configuration, the
system automatically resynchronizes the volume using the new disk. Resynchronization
might take several hours, depending on the disk size. You can continue to use your
storage system, although access is slower until the volume resynchronization finishes.
For more information about RAID configurations, see the ReadyNAS OS 6.2 Software
Manual, which is available at
ReadyNAS OS 6 Desktop Storage Systems
http://support.netgear.com/product/ReadyNAS-OS6.
Disks
109