Advertisement
Electronic Monitor & Diagnostic System
(continued)
#
The Electronic Monitor and
Diagnostic System
alerts you when
something starts to go wrong.
If a diagnostic code appears on
the display, something needs
special attention.
To get your
attention, the display code flashes
until you erase it. The first 6
flashes are accompanied by beeps.
If more than one coded function
requires attention at the same
time,
the one with the highest
priority will be displayed first.
Pressing the SYSTEM CHECK-
RESET pad will evaluate all other
coded functions. If the NORMAL
display is lit during the displaying
of a code, that function is operating
properly.
Pressing the SYSTEM CHECK-
RESET pad will erase three codes
immediately—~~
Cl and CC.
The
DE
and FFcodes can only be
erased by touching the SYSTEM
CHECK-RESET pad after the
condition that caused the code to
flash has been corrected.
This flashing code tells you to
check your frozen food.
Has any
of it started to thaw? A package
may be holding the freezer
compartment door open. Don't
open the door more often than
absolutely necessary while this
code is displayed. Touching the
SYSTEM CHECK-RESET
pad
after the freezer compartment
temperature has returned to
normal will erase the code.
This flashing code tells you the
This flashing code tells you
power to the refrigerator has
something's wrong with the defrost
been interrupted
for more than 2
system—keep
doors closed to
seconds. Check the condition of
retain cold and call for service.
food in both the fresh food and
Code flashes until problem is
freezer compartments.
Touch
corrected.
SYSTEM CHECK-RESET
pad
to erase code.
There is no fault with the
refrigerator
when PF code
flashes.
This flashing code tells you to
This flashing code tells you to
check the automatic
icemaker.
check temperature
controls and
Ice clumps in the storage bin may
adjust them if necessary. (See
have stalled the icemaker. Follow
directions on page 5.) Touch
corrective measures described on
SYSTEM CHECK-RESET
pad
page 21. If water supply to the
to erase code. If code reappears
icemaker is not connected or not
after 4 hours, call for service.
turned on, make sure manual
icemaker switch is in the OFF
position (see page 11). Code stops
flashing when problem is corrected
or SYSTEM CHECK-RESET
pad
is touched.
.-. .
...—---- . --—. - — -— .
8
. .
. .
'----1 '
Advertisement
