Do you have a question about the SA36 and is the answer not in the manual?
Questions and answers
John
March 22, 2025
I’m looking for the S series chimney components for a model SC 36M/SC 36MB. I need to extend my chimney to prevent downdrafts
1 comments:
Mr. Anderson
March 22, 2025
The Martin Fireplaces SC 36M/SC 36MB model is compatible with the following S series chimney components for extending the chimney:
- SC S-2100+ or HT6103+ Insulated Chimney Sections: These insulated chimney sections are designed for safe and efficient venting. - Elbows: If directional changes are required, appropriate elbows from the S series chimney components should be used. - Supports and Brackets: These include wall supports, roof supports, and other necessary mounting hardware to secure the chimney extension. - Flashing and Storm Collars: These components help seal the chimney where it passes through the roof and protect against weather conditions. - Termination Caps: These are used at the top of the chimney to prevent debris and animals from entering while allowing proper ventilation.
Ensure that all components used for extending the chimney comply with the manufacturer's guidelines and local building codes.
This answer is automatically generated
Milton Penn
January 24, 2025
Can I install a fireplace blower into the SC36 fireplace. I have gas logs.
1 comments:
Mr. Anderson
February 10, 2025
No, a fireplace blower cannot be installed in the Martin Fireplaces SC36 when using gas logs. The installation of a blower requires proper airflow and clearance, which may not be compatible with gas log operation. Additionally, gas log systems generate heat differently than wood-burning setups, and adding a blower may interfere with safe operation. Always follow the manufacturer's guidelines for approved accessories and installation requirements.
This answer is automatically generated
P. Barber
March 5, 2025
Is there a source for parts for the SC36M fireplace pipe and cap? Ours was blown off in a wind storm and we cannot find a replacement.
Need help?
Do you have a question about the SA36 and is the answer not in the manual?
Questions and answers
I’m looking for the S series chimney components for a model SC 36M/SC 36MB. I need to extend my chimney to prevent downdrafts
The Martin Fireplaces SC 36M/SC 36MB model is compatible with the following S series chimney components for extending the chimney:
- SC S-2100+ or HT6103+ Insulated Chimney Sections: These insulated chimney sections are designed for safe and efficient venting.
- Elbows: If directional changes are required, appropriate elbows from the S series chimney components should be used.
- Supports and Brackets: These include wall supports, roof supports, and other necessary mounting hardware to secure the chimney extension.
- Flashing and Storm Collars: These components help seal the chimney where it passes through the roof and protect against weather conditions.
- Termination Caps: These are used at the top of the chimney to prevent debris and animals from entering while allowing proper ventilation.
Ensure that all components used for extending the chimney comply with the manufacturer's guidelines and local building codes.
This answer is automatically generated
Can I install a fireplace blower into the SC36 fireplace. I have gas logs.
No, a fireplace blower cannot be installed in the Martin Fireplaces SC36 when using gas logs. The installation of a blower requires proper airflow and clearance, which may not be compatible with gas log operation. Additionally, gas log systems generate heat differently than wood-burning setups, and adding a blower may interfere with safe operation. Always follow the manufacturer's guidelines for approved accessories and installation requirements.
This answer is automatically generated
Is there a source for parts for the SC36M fireplace pipe and cap? Ours was blown off in a wind storm and we cannot find a replacement.