Lenovo ThinkPad T40 Hardware Maintenance Manual page 67

Hide thumbs Also See for ThinkPad T40:
Table of Contents

Advertisement

Symptom or error
1803
Unauthorized daughter card is
plugged in—Turn off and
remove the daughter card.
1810
Hard disk partition layout error.
2000
IBM Hard Drive Active
Protection sensor diagnostics
failed.
Press <Esc> to continue.
Press <F1> to enter SETUP
ThinkPad T40/T40p, T41/T41p, T42/T42p Series
Downloaded from LpManual.com Manuals
Symptom-to-FRU index
FRU or action, in sequence
1. Remove the daughter
card that you installed.
2. System board.
1. If the Access IBM
Predesktop Area has been
previously disabled, then
go to the BIOS Setup
Utility by pressing F1 to
open the BIOS Setup
Utility. Select Security -->
Predesktop Area -->
Access IBM Predesktop
Area. Set this item to
Disabled. Save and exit.
2. If the Access IBM
Predesktop Area has not
been previously disabled,
press Enter to load Access
IBM Predesktop Area. Then
run RECOVER TO
FACTORY CONTENTS in
Access IBM Predesktop
Area.
3. If item 2 failed, press F3 in
the Welcome screen in
RECOVER TO FACTORY
CONTENTS. Run FDISK,
and then delete all
partitions. Run RECOVER
TO FACTORY CONTENTS
in Access IBM Predesktop
Area again.
4. If item 3 failed, select
CD-ROM boot in Startup in
Access IBM Predesktop
Area. Boot from the
Recovery CD and perform
full recovery from it.
5. If item 4 failed, replace the
hard disk drive.
1. Undock docking station or
port replicator if it is
attached to the ThinkPad
computer, and place the
computer on a horizontal
surface. Do not apply any
physical shock to the
computer.
2. Run Diagnostics --> Other
Devices --> HDD Active
Protection Test.
61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents