GE DDE7905S Use And Care Manual page 6

HOW TO OPEMTE YOUR DRYER
WARNING—To reduce the risk of fire, electric shock, or injury to persons when using your
appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
DDE7905S and DDG7985S
DDE7900S and DDG7980S
ERM. PRESS
HIGH HMT+
\
FLUFF
NO HUT
Set the Controls —
Select the proper heat for
your load.
Drying Automatic
Selections Regular cycle
I
Cottons
I
Perm. Press
Medium Heat
Low Heat
Fluff*
No Heat
*Fluff-No Heat option can be used with an automatic cycle, but for
best performance it is recommended to be used with a timed cycle.
NOTE: Drying times will vary according to the
type of heat used (Electric, Natural gas or LP
gas), size of load, types of fabrics, wetness of
clothes, and condition of exhaust ducts.
I
6
See the Suggested Fabric and Drying Selection guide.
Automatic
Perm. Press and
Timed
Knits Cycles Cycles
I I
I I
Regular
OFF
desired cycle setting. The selector may be turned
in either direction.
Extra Care Cycle.
Operates only with the Automatic
Perm. Press and Knits cycles. For models DDE7905S
and DDG7985S press the pad, to select. For models
DDE7900S and DDG 7980S turn the control knob to
SET. To minimize wrinkle setting in clothes, the Extra
Care cycle provides approximately 15 minutes of no-
heat tumbling after the clothes are dry. Use End Cycle
Signal if your dryer has one. Signal will sound to
remind you to remove the clothes.
Reset Options if you wish to change an option.
the Push to Start button to start the dryer. For models
DDE7900S and DDG 7980S turn the Start knob to
start the dryer. (Opening the door during operation
stops the dryer. To restart, close the door and follow
above directions.)
bee ;::
& Kn;ts