Shuang ma 9101 Instruction Manual

Shuang ma 9101 Instruction Manual

Wireless rc

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 9101 and is the answer not in the manual?

Questions and answers

BRIAN GROFF
January 27, 2025

batteries installed proper and transmittor light lit. Charged fuselage. conected..lights on chopper lit but the blades dont turn at all. up and down on control, nothing.???

1 comments:
Mr. Anderson
February 10, 2025

The blades of the Shuang Ma 9101 helicopter may not be turning despite the transmitter light being lit and the batteries being installed properly due to the following possible reasons:

1. Helicopter Not Turned On – Ensure that the helicopter's power switch is turned on.
2. Battery Not Properly Connected – Check if the battery is securely connected to the helicopter.
3. Battery Needs Charging – The helicopter's battery may be low; charge it for 30-40 minutes.
4. Transmitter Not Synced – Ensure the transmitter and helicopter are on the same frequency (either 49 MHz or 27 MHz).
5. Throttle Sensitivity Setting – If the sensitivity setting is too low, the blades may not start spinning immediately. Adjust the sensitivity to the middle position.

If these steps do not resolve the issue, further troubleshooting may be needed.

This answer is automatically generated

Related Products for Shuang ma 9101

Table of Contents

Save PDF