Do you have a question about the NX-4 and is the answer not in the manual?
Questions and answers
Michael Mulhall
March 23, 2025
I can’t get the alarm to stop beeping.
1 comments:
Mr. Anderson
May 14, 2025
To stop the NetworX NX-4 alarm from beeping, you may need to exit programming mode and wait about 30 seconds for the system to clear. If it doesn’t stop beeping, troubleshooting may be required. You can also check and adjust settings like panic options by entering programming, making changes, pressing * to save, and then pressing # to exit.
This answer is automatically generated
Greg
September 8, 2025
I have inherited this system with a property I have bought, vendors had a user code but do not know the master code. Have tried the default (1234) without any look - I have access to the circuit board etc, is there a way to reset the master code?
elizabeth
August 23, 2025
when i exit it beeps and I have to reenter the code. I used to just enter the code once. this happen when i disarm as well. Why is this? how do I rectify it
Need help?
Do you have a question about the NX-4 and is the answer not in the manual?
Questions and answers
I can’t get the alarm to stop beeping.
To stop the NetworX NX-4 alarm from beeping, you may need to exit programming mode and wait about 30 seconds for the system to clear. If it doesn’t stop beeping, troubleshooting may be required. You can also check and adjust settings like panic options by entering programming, making changes, pressing * to save, and then pressing # to exit.
This answer is automatically generated
I have inherited this system with a property I have bought, vendors had a user code but do not know the master code. Have tried the default (1234) without any look - I have access to the circuit board etc, is there a way to reset the master code?
when i exit it beeps and I have to reenter the code. I used to just enter the code once. this happen when i disarm as well. Why is this? how do I rectify it