Do you have a question about the NB2950 and is the answer not in the manual?
Questions and answers
Malcolm K McKay
May 12, 2025
I have a Robin NB2950 and need to know how to put the cutter blade and nylon cutting head back on it. The parts are all off it. The manual does not give me a clear view. Any help would be appreciated.
1 comments:
Mr. Anderson
May 21, 2025
To reattach the cutter blade and nylon cutting head on a Robin NB2950, follow these steps:
1. Turn off the engine and disconnect the spark plug for safety.
2. Remove any existing attachment: - If a nylon head is attached, unscrew it by holding the shaft and turning the head counterclockwise.
3. Install the cutter blade: - Place the blade over the drive shaft, aligning it with the center hole. - Insert the locking washer or blade holder over the blade. - Secure with the blade nut. Tighten the nut using a wrench while locking the shaft (usually with a locking pin or tool inserted into the gearbox to prevent rotation). - Ensure the blade is tight and secure.
4. Install the nylon cutting head (if switching from blade): - Remove the blade and its hardware. - Screw the nylon head onto the shaft in a clockwise direction (may vary depending on thread direction). - Hold the shaft securely while tightening.
5. Check for tightness and alignment before use.
Note: Use only compatible parts and ensure all components are properly secured.
Need help?
Do you have a question about the NB2950 and is the answer not in the manual?
Questions and answers
I have a Robin NB2950 and need to know how to put the cutter blade and nylon cutting head back on it. The parts are all off it. The manual does not give me a clear view. Any help would be appreciated.
To reattach the cutter blade and nylon cutting head on a Robin NB2950, follow these steps:
1. Turn off the engine and disconnect the spark plug for safety.
2. Remove any existing attachment:
- If a nylon head is attached, unscrew it by holding the shaft and turning the head counterclockwise.
3. Install the cutter blade:
- Place the blade over the drive shaft, aligning it with the center hole.
- Insert the locking washer or blade holder over the blade.
- Secure with the blade nut. Tighten the nut using a wrench while locking the shaft (usually with a locking pin or tool inserted into the gearbox to prevent rotation).
- Ensure the blade is tight and secure.
4. Install the nylon cutting head (if switching from blade):
- Remove the blade and its hardware.
- Screw the nylon head onto the shaft in a clockwise direction (may vary depending on thread direction).
- Hold the shaft securely while tightening.
5. Check for tightness and alignment before use.
Note: Use only compatible parts and ensure all components are properly secured.
This answer is automatically generated