Do you have a question about the XP2-SSi and is the answer not in the manual?
Questions and answers
Lorn tardif
March 5, 2025
I followed every direction for binding my team associate xp2-ssi controller and it keeps flashing red-green. Battery's are all full and I don't know what else I could do. Does anyone have any advice I'd really appreciate.
1 comments:
Mr. Anderson
March 5, 2025
A flashing red-green light on the Associated Electrics XP2-SSi controller typically indicates a signal or calibration issue rather than a battery problem. Here are some possible causes and solutions:
1. Signal Interference or Loss: - Ensure the transmitter and receiver are properly bound. - Check for nearby electronic interference. - Move to a different location to test the controller.
2. Throttle Calibration Issue: - Turn off the controller and transmitter. - Rebind and recalibrate the throttle following the manufacturer's instructions.
3. Faulty Connection or Wiring: - Inspect all wiring connections. - Check for loose or damaged wires.
4. ESC Overload or Protection Mode: - Ensure the motor and ESC are not overheating. - Disconnect and reconnect the battery to reset the ESC.
5. Firmware or Internal Error: - If none of the above solutions work, consult the manual for reset instructions. - Contact the manufacturer for further troubleshooting.
If the issue persists, replacing the receiver or ESC may be necessary.
Need help?
Do you have a question about the XP2-SSi and is the answer not in the manual?
Questions and answers
I followed every direction for binding my team associate xp2-ssi controller and it keeps flashing red-green. Battery's are all full and I don't know what else I could do. Does anyone have any advice I'd really appreciate.
A flashing red-green light on the Associated Electrics XP2-SSi controller typically indicates a signal or calibration issue rather than a battery problem. Here are some possible causes and solutions:
1. Signal Interference or Loss:
- Ensure the transmitter and receiver are properly bound.
- Check for nearby electronic interference.
- Move to a different location to test the controller.
2. Throttle Calibration Issue:
- Turn off the controller and transmitter.
- Rebind and recalibrate the throttle following the manufacturer's instructions.
3. Faulty Connection or Wiring:
- Inspect all wiring connections.
- Check for loose or damaged wires.
4. ESC Overload or Protection Mode:
- Ensure the motor and ESC are not overheating.
- Disconnect and reconnect the battery to reset the ESC.
5. Firmware or Internal Error:
- If none of the above solutions work, consult the manual for reset instructions.
- Contact the manufacturer for further troubleshooting.
If the issue persists, replacing the receiver or ESC may be necessary.
This answer is automatically generated