Table of Contents
Advertisement
1.5 Panel Mounting Instruction
1.
Cut a mounting hole in the panel. (Refer to PPC‐150T Dimensions
on page 11~12.) (Note 1)
2.
Check and remove the twelve M3 screws in a diagonal pattern as
image below if necessary.
3.
Place PPC‐150T face‐down on a clean, flat surface.
4.
Slide the panel cutout around the back of PPC‐150T, until the panel
rests directly on the gasket. Make sure the screw holes align with
the screw holes on PPC‐150T.
5.
The screw size is M3*L (L=wall thickness + 6.0mm) (Note 2)
6.
Insert all twelve M3 screws into the screw holes. (Note 2)
7.
Finger-tighten the M3 screws. Finish tightening the M3 screws in a
diagonal pattern using an M3 screw driver (see the image as below);
maximum torque 1.18Nm (12 kgf‐cm).
○
1
○
9
○
12
○
4
PPC-150T User's Manual
○
5
○
8
IUMPPC150T-01 Ver.1.0A Jun, 2014
○
7
○
3
○
2
○
6
9
○
11
○
10
Advertisement
Table of Contents
