Advertisement
Outer Housing x 1
Inner Housing x 1
1. Insert Rubber Bumper in Inner
Housing End Cap and pull to snap in
place.
3. Insert second Rubber
Bumper into Inner
Housing and pull using
pliers to snap in place.
5. Screw PCB onto Inner Housing
making sure wires are connected as
shown.
7. Insert Magnet into Inner Housing
and push Inner Housing End Cap into
place.
9. Keeping Outer Housing in
same position as in step 8
carefully insert Inner Housing
and rotate until it fits fully
inside.
Contents
Switch Cover x 1
PCB x 1
Inner Housing End Cap x 1
Assembly
2. Cut off excess rubber
from Rubber Bumper.
4. Cut off excess rubber.
6. Insert L.E.D. and into
Inner Housing and make
sure L.E.D. is pushed fully
into place.
Make sure the flat side of
the L.E.D. lines up with the
flat side of the L.E.D. socket.
8. Locate switch in hole in
Flashlight Body.
10. Place Lens in place with
domed side facing up and
screw shut with End Cap.
Magnet x 1
Rubber Bumper x 2
End Cap x 1
Lens x 1
LED Bulb x 1
Screw x 4
Switch x 1
Advertisement
