Imagine NX1012DS Installation And Quick Start

NX1012DS INSTALLATION

QUICK START

1. Verify the contents
• 1 RU chassis (1)
• Power cables (2)
Rack rail kit contains the following:
• Rails (2)
• Slides (2)
• Short extensions (2)
• Nut plates (6)
• Bag of screws
3. Attach the cables to the back panel
 


Serial Port

RJ-45 IPMI LAN Port

If the customer orders the
NX-ASI-44 card, place the card in
the PCIe x8 bottom slot.
2. Rack mount the Delay Server

Attach a slide to each side of the
chassis using (5) M4x10mm
screws on each side. Make sure
the plastic retaining mechanism
is located at the back of the
chassis.

Attach an extension to the back
of each rail to match the depth of
your rack.

Attach the rails to the rack posts.

Slide the chassis into the rail.

To remove the chassis from
the rack:
Stand in front of the unit and pull
the chassis out as far as it will go.
On the left side, press down on
the plastic retaining mechanism.
On the right side, press up on
the plastic retaining mechanism.

  
  
Eth1 (NIC 2)
VGA for Video USB (4)
 
Power Supply (2) Eth0 (NIC 1)
Input 0:3 Input 0:2 Input 0:1
Reference Input Output 0:3 Output 0:2

rear rack posts
rail

Optional NX-GE-4
4. Start up the Delay Server and set up the system
Access the Delay Server
Confi guration Menu

Connect the Delay Server to your local KVM.

Press CTRL+ALT+F3 to view the third available terminal.
Optional NX-ASI-44

At the login prompt, type root and press Enter.

At the password prompt, type DTVinabox and press
Enter.

At the # prompt, type stopdtp and press Enter.

At the # prompt, type cd/home/ and press Enter.
Input 0:0
Output 0:1 Output 0:0

At the # prompt, type sh confi gureds.sh and press
Enter.


front rack posts

slide
Use the DTP menu to confi gure your Delay Server device
to the network.