Table of Contents
Advertisement
3. Pairing
Pairing the subwoofer is essential for receiving transmission signals
from the docking station.
To set-up subwoofer to either zone:
a. Press the PAIR located at the bottom of docking station.
b. Point remote control at the docking station and press down on
Zone 1 or Zone 2 button, and the connect indicator light on docking
station will flash rapidly.(AUX indicator will flash when pairing
Zone 2).
c. Make sure Subwoofer is powered on.
d. Use the pin(included) to press PAIR button on subwoofer. The
indicator light will
e. Press PAIR button on docking station again to complete setup.
Refer to AB-S10 Owner's Manual for more information about pairing.
Bass volume control
Rotate the bass volume dial to adjust the volume.
Crossover frequency
Slide the switch to select the crossover frequency: 80, 120 or 160
Hz for different bass effect. This setting is dependent on the music
content.
Phase adjustment
Depending on your room configuration, set the Phase Adjustment to
your liking.
Feel free to move the subwoofer around your house to find the
optimal location.
EASY SETUP
blink rapidly.
GB-6
Advertisement
Table of Contents
