Balance Meteo LED Weather Station User Manual

Balance Meteo LED Weather Station User Manual

Led weather station with 433 mhz remote sensor

Advertisement

LED Weather Station with 433 MHz
Remote Sensor
User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LED Weather Station and is the answer not in the manual?

Questions and answers

Summary of Contents for Balance Meteo LED Weather Station

  • Page 1 LED Weather Station with 433 MHz Remote Sensor User’s Manual...
  • Page 2: Functions Of The Weather Station

    FUNCTIONS OF THE WEATHER STATION This LED weather station measures the ambient temperature and atmospheric pressure for weather forecasting. Moreover, equipped with a 433MHz radio frequency (RF) interface, it can receive data from up to three remote sensors for outdoor temperature measurement within a distance of 100 feet (30 meters) in open space.
  • Page 3: Description Of Buttons

    M. Wall mounting hole For wall-mounting of the weather station DESCRIPTION OF BUTTONS The LED weather station has 8 buttons on the rear side 1. [ ] button - Press once to switch from clock mode to alarm time display mode...
  • Page 4: Getting Started

    - Toggle to display the Max/Min reading of the Indoor & Remote Temperature. - Press & hold for 2 seconds to clear the memorized Max/Min readings of the Indoor channel or the selected remote channel. 3. [MENU/SETUP] button Press and hold 2 seconds to enter clock setting mode 4.
  • Page 5 100 feet (30 meters). Once a remote sensor is registered, this LED weather station will display its temperature in the corresponding remote channel. Note: This LED weather station must work with the adaptor. If the user removes the...
  • Page 6: Transmission Range

    LED weather station will turn off the display, save the last reading of the temperature and weather forecast; keep running the internal clock with the backup battery. The LED weather station will start RF searching mode for 2 minute after plug in the adaptor.
  • Page 7 DCF 77 RADIO CONTROLLED CLOCK The remote sensor receives the time signal transmitted by Physikalisch-Technische Bundesanstalt (PTB) of Germany, which is regulated by 4 atomic clocks and in average deviates less than 1 second in 2 million years. PTB transmits the time signal (DCF77, 77.5kHz) continuously from Mainflingen, 25 km southeast of Frankfurt (am Main).
  • Page 8 ] button to decrease by one hour to the desired hours. Holding down the button will initiate the fast increments/decrements. Press the [ ] button to confirm. 5. The minute digits will be flashing. Use the [ ] button to increase by one minute or the [ ] button to decrease by one minute to the desired minutes.
  • Page 9 How to display Max/Min temperature Press the [MAX/MIN] button to display the memorized maximum indoor and outdoor temperature on the channel displayed for 6 seconds. Press this key again to display the memorized minimum indoor and outdoor temperature on the channel displayed for 6 seconds. While the maximum/minimum value on one channel is displayed, press the [CH] button to display the maximum/minimum values on another channel.

Table of Contents