Something Not Working - Electrolux EDC 66150W User Manual

22 electrolux something not working

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please carry
out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to indicate
that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the
programme. If after all checks, the problem persists, contact your local Service Centre.
I I M M P P O O R R T T A A N N T T : : if you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Malfunction
Dryer does not work.
Drying results
unsatisfactory.
Possible cause
Mains plug is not plugged in
or fuse is not working
correctly.
Loading door is open.
Have you pressed the
START/ PAUSE button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
standard setting of machine.
Solution
Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
Close loading door.
Press the START/PAUSE
button again.
Select a different programme the
next time you dry (see "Overview
of programmes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended
loading volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs
Re-programme standard setting
for degree of drying (see
'Programming options' section).