Assembly Overview - Out There Laser User Manual

22

ASSEMBLY OVERVIEW

(See following pages for detailed instructions)
1) Assemble rig by connecting mast tubes and sliding
assembled mast into sail pocket. Slide boom into
gooseneck.
2) Insert keel into slot at bottom of hull and
slide into place, turning locking lever to secure.
3) Place rudder into hole in bottom of hull and
snap rudder into bracket.
1
5
6
2
3
4) Place 4 AA batteries into battery holder.
Place battery holder into hull and close hatch
cover. Also, remove back of transmitter and
install 8 AA batteries.
5) Slide mast into hole on deck.
6) Connect sheet line to slider by pulling
loop at end of sheet line over slider tang
until loop hangs from slider ring.
7) Turn transmitter on, then turn
boat on by sliding switch forward.
4
7
You are now ready to sail!
3