Reading The Tuning/Battery Meter; Using The P.a. (Public Address) Function - Radio Shack Multi-Band AC/DC Portable Radio Owner's Manual

Table of Contents

Advertisement

12-795.fm Page 11 Friday, July 16, 1999 7:11 AM
9. To select a different station/fre-
quency, rotate
TUNING
knob) on the front of the radio. The
yellow bar on the multi-band scale
moves to indicate the current tuning
position. The needle on the
meter moves toward
BATTERY
the signal strength increases or
toward
as it decreases (see
0
"Reading the TUNING/BATTERY
Meter).
Notes:
• If you selected the
DIRECTION FINDER
tional AM antenna) on top of the
radio to fine tune the selected AM
station.
• If you selected the
band, rotate
FINE TUNING
knob inside
TUNING
the selected SW frequency.
10. To turn off the radio when you finish,
set
to
POWER
OFF
READING THE TUNING/
BATTERY METER
The radio's
TUNING/BATTERY
dicates the current signal strength and
the current battery strength (if you in-
stalled batteries).
(the outside
TUNING/
as
10
band, turn
AM
(the direc-
or
SW1
SW2
(the
) to fine tune
.
meter in-
With
set to
POWER
ON
set to
, the position of the needle
RADIO
on the top portion of the meter shows
the current signal strength on a scale of
0 (weakest signal) to 10 (strongest sig-
nal).
With
set to
POWER
ON
set to
, the position of the needle on
P.A.
the lower (green-shaded) portion of the
meter
shows
the
strength. The needle points toward the
right when the battery strength is strong,
and moves to the left as the battery
strength weakens.
USING THE P.A. (PUBLIC
ADDRESS) FUNCTION
Follow these steps to connect a micro-
1
phone with
/
-inch (3.5-mm) plug (not
8
supplied) to the radio and set the radio
so you can hear sound from the micro-
phone through the radio's speaker.
Note: Your local RadioShack store car-
ries a wide selection of microphones.
1. Turn
toward
VOLUME
stops.
and
RADIO/P.A.
and
RADIO/P.A.
current
battery
until it
MIN
11

Advertisement

Table of Contents
loading

Table of Contents