Setup; Unfolding The Handle - McCulloch 96188000400 Owner's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1.
No parts required
2.
Carriage bolts
Flange nuts
Washers
Knob
Chute
Deflector

1. Unfolding the Handle

Procedure
1. Loosen the two handle knobs and pull out the two
handle bolts until you can move the handle freely and
rotate the handle to the operating position (Figure 2).
1
2
1. Handle knobs
2. Tighten the handle knobs until they are snug (Figure 3).
Description
Figure 2
2. Handle bolt
Figure 3
Qty.
– Unfold the handle.
5 Install the discharge chute.
4 Install the discharge chute.
2 Install the discharge chute.
1 Install the discharge chute.
1
1
2. Installing the Discharge
Chute
5 Carriage bolts
4 Flange nuts
2 Washers
1 Knob
1 Chute
1 Deflector
Procedure
Install the discharge chute as shown (Figure 4).
3 4
3
1. Deflector
2. Carriage bolts
3. Flange nuts
IMPORTANT: Do not overtighten the flange nuts;
otherwise you may damage the discharge chute.
5
Use
1
4 5
2
Figure 4
4. Washer
5. Knob
6. Discharge chute
6