Setup > Mac Address Clone; Setup > Advanced Routing - Linksys WRT160N User Manual

Chapter3
TZO.com
Setup > DDNS > TZO
E-mal Address, TZO Key, and Doman Name
settings of the account you set up with TZO.
Internet IP Address The Router's Internet IP address is
displayed here. Because it is dynamic, it will change.
Status
The status of the DDNS service connection is
displayed here.
Update
To manually trigger an update, click this button.
Click Save Settngs to apply your changes, or click Cancel
Changes to cancel your changes.
Setup > MAC Address Clone
A MAC address is a 12-digit code assigned to a unique
piece of hardware for identification. Some ISPs will require
you to register a MAC address in order to access the
Internet. If you do not wish to re-register the MAC address
with your ISP, you may assign the MAC address you have
currently registered with your ISP to the Router with the
MAC Address Clone feature.
Setup > MAC Address Clone
MAC Address Clone
Enabled/Dsabled
To have the MAC Address cloned,
select Enabled.
MAC Address Enter the MAC Address registered with
your ISP here.
Wreless-N Broadband Router
Clone My PC's MAC
address of the computer you are using.
Click Save Settngs to apply your changes, or click Cancel
Changes to cancel your changes.
Setup > Advanced Routing
This screen is used to set up the Router's advanced
functions. Operating Mode allows you to select the
type(s) of advanced functions you use. Dynamic Routing
automatically adjusts how packets travel on your network.
Static Routing sets up a fixed route to another network
destination.
Enter the
Advanced Routing
NAT
Enabled/Dsabled
connection to the Internet, keep the default, Enabled. If
another router exists on your network, select Dsabled.
When the NAT setting is disabled, dynamic routing will be
enabled.
Dynamic Routing (RIP)
Enabled/Dsabled
automatically adjust to physical changes in the network's
layout and exchange routing tables with the other router(s).
The Router determines the network packets' route based
on the fewest number of hops between the source and
the destination. When the NAT setting is enabled, the
Dynamic Routing feature is automatically disabled. When
the NAT setting is disabled, this feature is available. Select
Enabled to use the Dynamic Routing feature.
Static Routing
A static route is a pre-determined pathway that network
information must travel to reach a specific host or network.
Enter the information described below to set up a new
static route.
Advanced Configuration
Click this button to clone the MAC
Setup > Advanced Routing
If this Router is hosting your network's
This feature enables the Router to
10