Gas Conversions - Whirlpool 8053365 Installation Instructions Manual

Table of Contents

Advertisement

Check operation
E
(cont.)
If your oven has this type of electronic
control pads:
888°
88:88
ON
F
HEAT BAKE
BROIL
TIMER
TIMER
SET
CUSTOM
TEMP
CLOCK
LIGHT
BAKE
TEMP
BROIL
TIMER
OFF
C
1. Press the "CUSTOM BROIL" pad.
• "HI" will appear in the display.
• The "BROIL" indicator will light.
2. Press the "START/ENTER" pad.
• "HEAT"and "ON" indicators will light.
• The oven burner should light in 50-60
seconds; this delay is normal. The oven
valve requires a certain time before it will
open and allow gas to flow.

Gas conversions

Gas conversions (from Natural gas to L.P. gas; or
from L.P. gas to Natural gas) must be done by a
qualified installer.
WARNING
Fire Hazard
Shut off gas supply line valve.
Make all conversions before turning gas
supply valve back on.
Failure to follow these instructions could
result in explosion, fire or other injury.
Page 7
21.
operating.
22.
"OFF/CANCEL" pad.
START
OFF
HR
MIN
ENTER
CANCEL
5 SEC
CANCEL
L.P . gas conversion
1.
Complete installation sections A-C (Pages
4-5) before converting cooktop to L.P. gas. Check
that main gas supply line has been shut off and
the power supply cord is disconnected.
electrode
screws
2.
Remove burner grates, caps and screws
holding burner bases to cooktop. Lift burners off
cooktop.
Check that the broil burner is
Close the broiler drawer. Press the
burner base
cap
You have just finished installing
your new range. To get the most
efficient use from your range, read your
Use & Care Guide.
Keep Installation Instructions and Guide
close to range for easy reference.
The instructions will make installing the
range in another home as easy as the
first installation.
pressure
regulator
pressure
regulator
cap
washer
DO NOT REMOVE THE PRESSURE REGULATOR.
3.
Open broiler drawer to locate pressure
regulator.
Pressure regulator: Remove plastic cover. Turn
cap marked "N" on front of pressure regulator
counterclockwise with a wrench to remove. Do
Not disturb or remove the spring beneath the
cap. Turn the cap over and reinstall cap on
regulator so that the letters "L.P." are visible.
Replace plastic cover over cap.
Natural
plastic
cover
L.P.
plastic
cover
L.P. gas

Advertisement

Table of Contents
loading

Table of Contents