Advertisement
CLEANING
Beforecleaning,tum off the machine, unplugit, and allow to
cool down.
The filterholder,filter basket,carafe,carafe lid,the cup adapter
and the overflowgrid can be put in the dishwasher'supper rock
awayfrom the heatingldryingelement
The machine itsetf wipes clean. Never immerse the body of
your"EspressoMini"in water or any other liquid•Clean the
filter ringwith adamp cloth and remove groundcoffee. If there
iswater left in the boiler container,let the machine cool down,
removeaiTloose parts and empty throughthe top opening.
Cleaning
the steam
nozzle
Clean the steam nozzle each time after you have immersed
it in the milk, other,vise the inside of the noTAe becomes
clogged and milk deposits on the outside harden and become
dh'l_cultto remove, if this does occur, unscrew the nozzle (see
figure 15) and remove all milk particles (use a needle and rinse
under faucet); replace nozzle, and be sure to screw on tightly.
Cleaning
the Perfect
Froth attachment
For a thorough cleaning of the "Perfect Froth" attachment
remove part C (see figure 12a). All parts should be dnsed in
warm water. Ifthe small suction opening in part A is clogged it
can be opened with a fine needle,
_
CAUTION
DO NOT try to open or disassemble the main body of the
machine.
14
PROBLEMS
AND CAUSES
(Alwayscheck if machine is plugged in and if machine is in the proper "On" position.)
Problem:
1•Coffee leaking fTom filter holder
Cause:
•
Filter holder not propedy inserted
•
Rlter holder not pushed in far enough
•
Intemal gasket is dirty, clean gasket
•
Gasket withoutelasticity,
replace
•
Coffee powder not cleaned off the edge of the filter holder
Probtem:
2. Coffee does not come out
Cause:
•
No water in boiler container
•
No coffee in filterholder
•
Filtercloggedup because coffee mixture is too fine or presseddown too hard
10
f
1
l
Problem:
3. Steam does not come out of steam nozzle
Cause:
•
NO water or enough water in the boiler container
•
Steam nozzle is clogged (see under "Cleaning")
•
Perfect Froth attachment
is clogged (see under"Cleaning
the Perfect Froth')
Problem:
4• Not enough froth when frothing the milk
CaUse:
• Perfect Frothattachment touchesthe bottom of the pitcher
• Perfect Frothtip (see figure 12a) is clogged (part A) (see under "Cleaningthe Perfect Froth")
Q Steam nozzleis clogged (see under"Cleaning")
• Not enough waterleftin boilerto steam for 45-60 seconds
Never move or remove the filter holder while the
machine is in operation and under pressure.
T
Limited One Year Warranty
Your KRUPS _t 963 is covered
by
the following
warranty (glass carafes
are excluded
from warranty):
If from date of purchase within one
year this KRUPS product fails to
function
because
of defects in
materials
or workmanship,
KRUPS
North America,
will at its option,
repair or replace the unit without
charge, provided the owner has a
proof of date of purchase:
This warranty will be void if
malfunction
was caused by
damage to the product
by
accident,
misuse, use on
frequency
or voltage
other than.
marked on the product and/or
described
in the instructions,
• abuse including
tampering,
damage
in transit, or use for
commercial
purposes.
This
warranty
gives you specific legal
rights, and you may also have
other rights which vary from state
to state.
tl
Advertisement
