Declaration Of Conformity; Troubleshooting Table - McCulloch MAC 838 Instruction Manual

TROUBLESHOOTING TABLE

WARNING:
Always stop unit and disconnect spark plug before performing all of
the recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not
1. Ignition switch off.
start or will run
2. Engine flooded.
only a few
seconds after
3. Fuel tank empty.
starting.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
Engine will 1. Idle speed requires
not idle adjustment.
properly. 2. Carburetor requires
adjustment.
Engine will not 1. Air filter dirty.
accelerate, 2. Spark plug fouled.
lacks power, 3. Chain brake engaged.
or dies under 4. Carburetor requires
a load. adjustment.
Engine 1. Too much oil mixed with
smokes gasoline.
excessively.
Chain moves
1. Idle speed requires
at idle speed. adjustment.
2. Clutch requires repair.

DECLARATION OF CONFORMITY

EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna AB, SE- -561 82 Huskvarna, Sweden, Tel: +46- -36- -146000, as authorised
representative in the Community, declare that the chain saw model McCulloch Mac 838
SAS-AV from serial numbers 2009- -031(N or D)00001 and onwards (the year is clearly stated
on the rating plate, followed by the serial number), comply with the requirements of the
COUNCIL'S DIRECTIVES:
of 22 June 1998 "relating to machinery" 98/37/EC, annex IIA;
of 15 December 2004 "relating to electromagnetic compatibility" 2004/108/EC, and applicable
supplements; and
of 8 May 2000 "relating to the noise emissions in the environment" in accordance with Annex
V of 2000/14/EC. The measured sound power is 108,7 dB(A), the guaranteed sound power is
113 dB(A) and the net power is 1,5 kW.
The following standards have been applied: ISO 11681- - 1:2004, EN/ISO 12100- - 1:2003,
EN/ISO 12100- - 2:2003, and CISPR 12:2001.
Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3 S- -754 50
Uppsala, Sweden, has carried out EC type approval. The certificate(s) is numbered:
404/05/1079.
The supplied Chain Saw conforms with the sample that underwent the EC type approval.
09- -1- -31
REMEDY
1. Move ignition switch to ON.
2. See "Difficult Starting" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug and regap.
3. Disengage chain brake.
4. Contact an authorized service dealer.
1. Empty fuel tank and refill with
correct fuel mixture.
1. See "Carburetor Adjustment" in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
Ronnie E. Goldman, Director of Engineering
Handheld Consumer Products
16