Advertisement
HOW TO OPEMTE YOUR DRYER
read the WORTANT SAFETY ~STRUCTIONS before operating this appliance.
0
Push To Stiti
Check the Lint Ffiter
Clean the lint filter each time the dryer is used. Always
be sure the lint filter is in place.
Do not run the dryer with the lint screen
A
loose, damaged, blocked or missing. Doing so
can cause overheating, damage fabrics and be a
fire hazard.
The lint screen is located inside
the dryer drum, on the back wall.
To clean:
1. Use the finger holes to pull the lint
screen straight out.
Sort and Load the Clothes
Good sorting for the dryer begins at the washer.
Generally, if clothes are sorted right for washing,
they're sorted right for drying. See the How to Sort
the Clothes section.
Set the Controls
See the Suggested Fabric and Drying Selections guide.
Turn the Cycle Selector to the desired cycle setting.
The selector may be turned in either direction.
NOTE: Drying times will vary according to the type of heat used (electric,
natural gas or LP gas), size of load, types of fabrics, wetness of clothes and
condition of exhaust ducts.
6
2. Lightly squeeze the body as shown
3. ROLL lint off the screen with
4. Replace the cover on the body of
5. Before replacing the lint screen,
6. Push the lint screen straight back until it snaps
Pull straight out
If you do mix various types of fabrics in your load,
set the controls for the lighter-weight fabrics and
remove when dry. Reset controls for the remaining
heavier fabrics
while puliing the cover off.
your fingers. Do not tinse or
wash the screen.
the-lint screen.
remove any lint from the wire mesh
on the back wall (behind the lint screen).
into place.
Press the Start button to start the dryer. (Opening
the door during operation stops the dryer. To
restart, close the door and press the Start button.)
,
,
.
.
0
\
Squeeze body;
pull cover off
—
Advertisement
