Do you have a question about the HT-3300A and is the answer not in the manual?
Questions and answers
Summary of Contents for Astar HT-3300A
Page 1
DVD HOME THEATRE SYSTEM DVD HOME THEATRE SYSTEM HT-3300A HT-3300A HT-3300A Built-in Dolby Digital decoding for maximum home entertainment enjoyment Unique laser-head over-current protection system doubles service life Special DVD deck features fully dustproof and anti shock design as well as augmented error...
To ensure proper use of this product, please read this owner's manual carefully and retain for future reference. Should the unit require maintenance, contact an authorized service centre. HT-3300A WARNING RISK OF ELECTRICSHOCK DO NOT OPEN REDUCE RISK OF...
IMPORTANT-- SAFETY INFORMATION CAUTION: It is important that you read and follow all of the instructions in this booklet and any marked on not be located in the vicinity of overhead power lines the unit itself. Retain this booklet for future reference. or other electric light or power circuits, or where it Accessories--- Never place this product on an un- can fall into such power lines or circuits.
JPEG FILES JPEG adoptting the most efficient compression is widely used as picture storage type flattened and stored format. Even if pictures are compressed 15-20 times.they still have good effect. Supported by most picture processing software,fit for picture storage, it has small data and easy use .This machine can read.
ABOUT YOUR DVD PLAYER The following will help you get the most enjoyment from your DVD receiver system. BEST LOCATION The unit should be placed on a firm, flat surface, away from VCRs, stereos, radios, or large speakers, as the magnetic flux from these devices may cause distortion in the sound and a poor picture.
SYSTEM SETUP Pink Noise Setting Pink Noise is test tone set to Off and select test LEFT, CENTER, RIGHT, RIGHT SURROUND and LEFT SURROUND channle. A. From Stop mode, press SETUP. B. Select More Audio and press ENTER. C. Select Pink Noise and press ENTER. D.
FRONT AND BACK PANELS Front Panel Functions HT-3300A DVD HOME THEATRE SYSTEM DVD/CD/CD-RW/HDCD 1. POWER Before plugging the power cord into the AC DVD mode. outlet, check to make sure all of the connections have been properly completed. When they have been, carefully plug power cord into outlet.
SYSTEM SETUP Select [Video Output], and press ENTER or to display the [Video Out] submenu: A . Press ENTER to confirm B. Press SETUP to exit the Setup Menu Note: The Composite video and S-video output is always available. [S-Video] -Select if you connected the DVD player to your TV using the composite Video output.
OPERATING THE REMOTE CONTROL Notes: Battery Installation 1. Push down and out on the battery Compart- ment cover to remove it. 2. Insert the two AAA batteries into the battery " " compartment of the remote control, making sure the + and - signs on the batteries and inside the battery compartment match up.
SYSTEM SETUP Language Setup Select [Subtitle], and press ENTER or Language Video Audio More Aud OSD Menu English Subtitle English English Audio English Auto DVD Menu English A. Press ENTER to confirm B. Press SETUP to exit the Setup Menu Select [Audio],and press ENTER or Language Video...
SPEAKERS The configuration and arrangement of a surround sound system's speakers is critical. ation may vary according to room size and wall material. The figure below illustrates a typical For maximum listening enjoyment, refer to the arrangement. Arrangement of Speakers section in this manual prior to connecting speakers.
FUNCTIONS REPEAT MENU: MENU/PBC With the PBC function on, choosing a song on a VCD can only be done when at the main menu. With the PBC function off, song selections can be made by entering the relevant number keys. The menu content of the disc will appear when the MENU button is pressed while a DVD disc is playing.
CONNECTING ANTENNA Radio signals may be difficult to receive in some buildings and under certain conditions. The provided antennas will help in their reception. They are intended for indoor use only. AM Loop Antenna The placement of the AM loop antenna should be in a direction that provides the clearest reception.
CONNECTING POWER SUPPLY POWER HT-3300A DVD HOME THEATRE SYSTEM DVD/CD/CD-RW/HDCD Before plugging the power cord into the AC outlet, check to make sure all of the connections have been properly completed. When they have been, carefully plug power cord into outlet.
PLAYING THE RADIO HT-3300A DVD HOME THEATRE SYSTEM DVD/CD/CD-RW/HDCD Positioning 1.Press TUNER button to select desired wave band (AM or FM). 2.Press UP or DOWN button to find a station. The frequency will change with each press. When a station's signal is received, it will appear in the display.
Need help?
Do you have a question about the HT-3300A and is the answer not in the manual?
Questions and answers