Advertisement

ELECTRONIC TREADMILL
3501

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3501 and is the answer not in the manual?

Questions and answers

Summary of Contents for York Pacer 3501

  • Page 1 ELECTRONIC TREADMILL 3501...
  • Page 2: Table Of Contents

    CONTENT 1.Safety regulation 2.Technical standard 3.Electronic meter 4.Main parts of Treadmill 5.Assembling 6.Adjusting&Testing 7.Operation Instructions 8.Points for attention 9.Drawing for system connecting 10.Maintenance 11.Some problems & settlement...
  • Page 3: Safety Regulation

    1. Safety regulations: Attention: Read carefully this manual before using the machine. ·The treadmill should be put indoors, keeping it free from moisture and splashes of water. Don't put anything onto the machine. ·During working sparks may occur in the electric motor. So keep the machine far from combustibles and exploder.
  • Page 4: Electronic Meter

    3.Electric Meter: 1. Safety key 1 2 3 4 5 6 7 8 9 2. Fast and low key 3. Calorie 4. Speed 5. Time 6. Slope 7. Distance 8. Slope up and down 9. Number 10. Pulse sencor 11. Stop 19 18 17 16 15 14 13 12 11 10 12.
  • Page 5: Assembling

    5.Assembling 1.Install left and right column: 2.Install tube of sencor meter: insert left and right column into Faxed the tube on the two col- bottom connector, fixed it with umns with M8 screws.(After install M8 screws. electric meter,then tighten it.) 3.Install electronic meter:Insert 4.Strictly prohibit disassembly it on the tube of two columns,...
  • Page 6: Operation Instructions

    7.Operation instructions: 1. Insert plug in the Jack of 240v, “fast and slow” motor will automatically re- cover. 2. Insert plug of “safety key” into “safety key” plug of instrument, press the button”start”key, the treadmill directly begins running. speed is about 1.0kilometers/h.
  • Page 7: Points For Attention

    8.Points for attention: 1. When using the treadmill for the first time, please begin with a slow speed, and raise the speed gradually. 2. The paces should be suited to the speed of belt. Treading the machine de- liberately is forbidden. 3.
  • Page 8: Drawing For System Connecting

    9.Drawing for system connection 10.Maintenance 1. Clearance: The treadmill should keep cleaning, Put off the plug first before cleaning, clean it every one to two months. When cleaning, open the cover, clean the dust on motor and sensor and then check if the screws are loosed. 2.
  • Page 9: 11.Some Problems & Settlement

    11.Some problems & settlement Problems Probability reason Measures 1.Machine can’t be started w h i l e m e t e r w o r k i n g The input voltage is too low 1.Adjust input voltage. normally or carton brush seriously 2.Replace brush or clean 2.Meter working normally, wear and tear.

Table of Contents