Electrolux EI30GF45QS Use And Care Manual page 43

Solutions to common problems
Problem Solution
• Meat too close to the broiler element. Reposition the rack to provide more
Oven smoke
clearance between the meat and the broiler. Preheat broil element for quick
excessively
searing operation.
during broiling
• Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty
edges to prevent curling, but do not cut into the lean.
• Grid on broiler pan wrong side-up. Grease does not drain into broiler pan. Always
place the grid on the broiler pan with the ribs up and the slots down to allow grease
to drip into the pan.
• Broiler pan used without grid or grid cover with aluminum foil. DO NOT use the
broiler pan without the grid or cover the grid with aluminum foil.
• Oven needs to be cleaned. Grease has built up on oven surfaces. Regular
cleaning is necessary when broiling frequently. Grease or food spatters cause
excessive smoking.
• Failure to clean bottom, from top of oven, frame of oven or door area outside
Soil not
oven seal. These areas are not in the self-cleaning area, but get hot enough
completely to burn on residue. Clean these areas before the self-cleaning cycle is started.
Burned on residue can be cleaned with a stiff nylon brush and water or a nylon
removed after
scrubber. Be careful not to damage the oven gasket.
self-cleaning
• Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
cycle is
completed
• Surface Control knob has not been completely turned to LITE. Push in and turn
Surface burners
the Surface Control knob to LITE until burner ignites and then turn control knob
do not light
to desired fl ame size.
• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burners. See Cleaning the Burner Grates,
Burner Caps, Burner Heads in General Care & Cleaning section. With the
burner off, clean ports with a small-gauge wire or needle.
• Power cord is disconnected from outlet (Electric Ignition Models only). Be sure
cord is securely plugged into the outlet.
• Electrical power outage (electric ignition models only). Burners can be lit
manually. See Setting Surface Controls in this Use and Care Guide.
• Burner ports are clogged. With the burner off, clean ports by using a small-gauge
Burner fl ame only
wire or needle.
lights half way
• Moisture is present after cleaning. Lightly fan the fl ame and allow burner to
around burner
operate until fl ame is full. Dry the burners thoroughly following instructions in the
General Cleaning section.
• Improper cookware. Select fl at-bottomed cookware of a proper size to fi t element.
Food not heating
• Incorrect control setting. Raise or lower setting until proper amount of heat is
evenly
obtained.
• Dust particles in main line. Allow the burner to operate a few minutes until fl ame
Burner fl ame is
turns blue.
orange
• In coastal areas, a slightly orange fl ame is unavoidable due to salt air. Ceramic-
Glass Cooktop section in this Owner's Guide.
Questions or for service call:
Before you call
1-877-4ELECTROLUX (1-877-435-3287)
43