Table of Contents
Advertisement
Available languages
Available languages
4.
Using pliers, tighten
the couplings
with
an additional
two-thirds
turn.
10. Using pliers, tighten
the coupling
with
an additional
two-thirds
turn.
NOTE: I)o not overtighten.
Damage
to the coupling
can result.
5.
Attach "Y" connector
to brass male end of small
hose. Screw on coupling
by hand until it
is seated on connector.
6.
Attach straight end of long hose to "Y" connector.
7.
Attach washer
cold inlet hose to other end of "Y" connector.
Screw on coupling
by hand
until it is seated on connector.
8.
Using pliers, tighten
the couplings
with
an additional
two-thirds
turn.
A
NOTE:
I)o not overtighten.
Damage
to the coupling
can result.
11. Check that the water faucets are on.
12. Check for leaks around
"Y" connector,
faucet
and hoses.
Check the levelness
of the dryer. Check levelness
first side to side, then front to back.
21!:
9.
A. Inlet to cold water
NOTE;
Do not overtighten.
Damage
to the coupling
can result.
Attach angled end of long hose to fill valve at bottom
of dryer back panel.
Screw on
coupling
by hand until it is seated on fill valve connector.
If the dryer is not level, prop up the dryer using a wood
block.
Use a wrench
to adjust the legs
up or clown and check again for levelness.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
