Use The Lcd Interface; Modes Of Operation - Watchguard SSL 560 Hardware Manual

Use the LCD Interface

The LCD interface has two parts: the LCD display and the LCD console button controls. You can use the LCD
display and buttons to complete many different operations.

Modes of operation

The SSL 560 can operate in two modes: Default Mode or Recovery Mode.
Default Mode
Default Mode is the normal operating mode. If necessary, you can reset your device to its factory-default
settings from default mode.
1. Connect to the Web UI.
2. Select Manage System > Device Update.
The Device Update page appears.
3. Click Restore factory defaults.
4. Start the Quick Setup Wizard and configure the device.
For more information about the Quick Setup Wizard, see the Help or the Quick Start Guide.
Recovery Mode
Recovery Mode puts your WatchGuard SSL device in a state where you can upload a new SSL OS image. Use
this mode only when you cannot connect to the device with the Web UI.
To put your device into Recovery Mode:
1. Press and hold the up arrow button while you power on the device.
2. Keep the button depressed until
3. In Recovery Mode, you can use FTP to upload a new version of SSL OS directly to the device.
For more information about how to put a WatchGuard SSL device into Recovery Mode, see the
WatchGuard SSL Help or User Guide.
Use the LCD console buttons
At the right of the LCD display are the four console control arrow buttons, which you can use to navigate the
device menu.
Left Arrow Button
Press this button to scroll to the left in a menu.
Right Arrow Button
Press it to scroll to the right in a menu and confirm your menu selections.
Up Arrow Button
Press this button to move up in a group menu.
Down Arrow Button
Press this button to move down in a group menu.
Hardware Guide
appears on the display.
Executing sysB
7