Scanning For Active Channels - Midland Micro Mobile MXT100 Manual

4. Press the Volume Up
decrease radio volume.
5. Once the radio volume has been adjusted to the desired level, press
the Monitor/Quiet Channel

Scanning for Active Channels

Your MXT100 includes an "auto-scan" mode that continuously scans all 15
available channels for activity. Additionally, if desired, you can remove one
or more channels from the list of scanned channels.
To enter and exit "auto-scan" mode:
1. Be sure the radio is turned on (see Power On/Off).
2. Quickly press and release the Scan
mode.
 The Scanning
is in "auto-scan" mode.
 Your radio will rapidly scan through the 15 available channels and
will pause on any active channel.
 "Auto-scan" will resume when there has been no activity on the
current channel for four seconds.
3. To transmit during "auto-scan," press and hold the PTT button on the
microphone while the radio is paused on the desired channel.
 The radio will remain on the active channel for three seconds after
the PTT button is released.
4. To exit the "auto-scan" mode, quickly press and release the Scan
button.
 The Scanning
"auto-scan" mode.
To remove a channel from "auto-scan" mode:
1. Be sure the radio is turned on (see Power On/Off).
2. Use the Channel Up
or backward through the available channels until the Channel icon for
the channel you wish to remove shows on the LCD display.
midlandusa.com
or Volume Down
button to exit Monitor mode.
icon will show on the LCD display when the radio
icon will turn off when the radio is no longer in
or Channel Down
button to increase or
button to enter "auto-scan"
button to scroll forward
Model MXT100
Page 15