Scanning Micr Characters - Oki PH640 User Manual

4-4. Scanning MICR Characters

The insertion direction for MICR paper varies according to the model.
For models with no MICR scanning head, MICR characters cannot be scanned.
For models with the MICR scanning head installed above, insert the MICR paper facing up.
For models with the MICR scanning head installed below, insert the MICR paper facing down.
Insert a MICR paper as follows:
(1) Turn the printer power switch ON.
(2) Make sure the SLIP lamp is flashing.
(3) As you face the printer, insert the paper straight, while sliding the right end of the MICR
paper against the right end of the slip paper slot.
Note: Sliding the paper diagonally can cause a paper jam.
If the paper gets jammed, press the RELEASE button to remove the paper. Then,
insert the paper again. (See "8-2. Removing Paper Jam" for details.)
(4) When the MICR paper reaches the scanning position, the SLIP lamp will turn ON.
Direction of MICR Paper on models with MICR Head installed above:
Direction of MICR Paper on models with MICR Head installed below:
Scanning
characters
Scanning
characters
– 21 –