›
Retighten the screws and insert the cap. The cap must engage firmly.
Replacing the bulb for the licence plate light
Read and observe
and
›
Open the tailgate and unscrew the glass cover
›
Remove the faulty bulb from the holder and insert a new one.
›
Replace the glass cover and push in until the stop. Make sure that you install
the rubber seal in the right direction.
›
Slightly screw the glass cover.
Tail light
Fig. 165 Removing the tail light assembly/disconnecting the plug connec-
tion
174
Do-it-yourself
Fig. 164
Remove the licence plate light
on page 171 first.
» Fig.
164.
Fig. 166 Remove the middle part of the light/bulb arrangement
Read and observe
and
Bulb arrangement in the tail light assembly
- Brake lights
1
- Turn signal lights
2
- Reversing light
3
- Rear fog light
4
- parking lights
5
Removing and installing the tail light
›
Open the tailgate.
›
Unscrew the light assembly
» Fig. 165
›
Grip the light in the upper and lower area and move backwards somewhat.
›
Unplug the connector
» Fig. 165
›
To access the bulbs, unscrew the middle of the light assembly and press off
the tabs
» Fig. 166
- .
›
To reinstall, screw the middle part of the light onto the housing of the rail
light.
›
Reconnect the plug connection and put the light into the original position.
›
Screw the light into place
Replacing the bulbs in the tail lamp assembly
›
Remove the faulty bulb
,
,
1
2
new bulb.
›
To replace the bulb, turn the bulb holder
and remove it from the housing.
›
Replace the bulb, insert the holder with the bulb into the housing and turn in
a clockwise direction to the the stop.
on page 171 first.
» Fig.
166.
- .
- .
or
» Fig. 166
from the holder and fit a
3
4
anti-clockwise up to the stop
5